Repair Procedure:
Reducers are completely disassembled, cleaned, wire brushed of all rust and grease, inspected, and tested as follows:
Measure all "fits" and compare with original drawing dimensions. Provide photographs and/or sketches for assembly.
Cases/housings are visually inspected for cracks and other signs of wear.
Shafts and Gearing are visually inspected and dimensionally checked to determine if acceptable for reuse.
Fits: All fits will be returned to original size and relative centers using either plating, sleeving and/or welding and machining as approved by the customer.

Shafts:
May be repaired by plating and grinding, or machining and sleeving.
New shafts will match the specifications and dimensions of the original part as per customer print. Exposed threads, shaft ends, and couplings will be protected with an anti-rust protection coating prior to shipping.
 

Gearing:
Will be dimensionally inspected and compared to manufacturer’s prints. New gearing will meet or exceed the specifications of the original parts per customer print.

Cases/Housings:

• All fits will be returned to original size and relative centers using sleeving or welding/machining as approved by the customer
• All bolts, studs, pipe plugs, and other fittings will be removed and holes re-tapped as necessary.
• Replacement bolts, studs, and pipe fittings will be of equivalent grade and material unless otherwise specified.
• Customer must approve any print modifications prior to implementation.

Assembly and Test Procedures:

• All seals, shims, gaskets, and bearings will be replaced.
• All hardware will be reused or replaced depending upon condition.
• All units will be run tested to check contact patterns, clearances, backlash, and freedom of movement.
• Exterior surfaces cleaned of all loose scale and rust.
• Entire Housing surfaces cleaned of all dirt and oil.

Highlights:

• TEAMSESCO repairs and tests all brands and types of Gear Motors including: Precision, Indexing, Parallel, In-Line, Shaft Mount, Planetary, Bevel, Cycloid, Helical, Harmonic, Spur, Worm, and Transmissions.
• Factory-trained technicians
• Warranty repair center
• Custom Gear Manufacturing
• Job tracking through TEAMSESCO’s Customer Web Portal